I am helping my niece with her 2006 Monster 620 and the idle speed is stuck around 800 RPM. This is way too low and the bike stalls all the time. I tried adjusting the air bypass screws on the throttle bodies but they barely change the engine speed at all. I have already checked the valves and the compression and both look good. The bike smells like it is running rich and it does not start as easily as it should. I even did a full sync with a meter and set the throttle position sensor to the standard 150 mv. Using the fast idle lever helps it stay at 1100 RPM where it runs fine but I want it to idle properly on its own. It seems like the mechanical settings are correct but the air screws just are not doing their job.